MSR Universal Footprint 2 Person
MSR Universal Footprint — 2 Person Regular. Protect the floor of your MSR Hubba Hubba, Bikepack, FreeLite 2 or Access 2 with this Regular-size groundsheet. It forms a separate layer beneath the tent to help reduce wear from rough ground and keep the floor cleaner when packing up.
Compatible MSR tents
- Hubba Hubba 2 (2022–2024 generation)
- Hubba Hubba NX (2-person)
- Hubba Hubba Bikepack 2
- FreeLite 2
- Access 2
Also fits these past-season models: Carbon Reflex 2; Thru-Hiker Mesh House 2.
Choose the right footprint
Hubba Hubba LT 2, Hubba Hubba HD 2, the current Elixir 2 and Remote 2 use the 2 Person Large footprint. Regular and Large are different groundsheet dimensions, so choose by the full tent model rather than sleeping capacity alone. For an older Elixir 2, confirm the model year with us first.
“Universal” refers to the range of available sizes, rather than one size fitting every MSR tent. If your model is not listed or you are unsure of its generation, contact us before ordering.
Why use a footprint?
- Helps reduce wear on the tent floor from grit and abrasive campsite surfaces.
- Adds a barrier against dirt and damp ground, keeping the underside of your tent cleaner.
- A separate groundsheet is easier to clean and dry after a trip.
A practical extra layer for multi-day tramping, especially where grit and repeated pitching can wear the tent floor.
Dimensions and weight
- Size: 2 Person Regular
- Groundsheet dimensions: approximately 208 × 122 cm
- MSR published weight: approximately 227 g
- Sold as: footprint only; tent and other equipment sold separately.
Setup and care
Clear sharp stones and debris from your pitch, lay out the footprint and centre your tent over it. Secure the corner loops and keep the footprint edges beneath the tent floor so rain cannot collect on exposed edges and run between the layers. The footprint is intentionally smaller than the tent floor.
Use this footprint for ground protection. Check your tent's instructions before attempting a fly-only pitch. Shake off dirt after use, clean gently when needed and allow the footprint to dry completely before storing.